Is Mighty putty actually good?

It held water with no problem and the handle didn’t break. Thanks to our sister station, KFVS, we were able to see that the Mighty Putty can actually pull 13,000 pounds if it cures for 24 hours. And, it was also able to hold three cinder block bricks, but not for a long time.

How strong is Mighty putty?

Powerful binding epoxy. Fix, fill and seal almost anything. Bonds to almost any surface. Holds up to 350 lbs.

Does epoxy putty come in colors?

Marine-Tex epoxy putty comes in white or gray colors, and ONLY the white Marine-Tex can be tinted.

How long does it take for Mighty putty to dry?

Use a putty knife or fingers to press putty into any cracks or depressions. Use within 2 or 3 minutes after mixing. At room temperature, putty will begin to harden in 3 to 7 minutes, sets hard in 12 to 20 minutes and can be sanded, drilled, machined or filed in about one hour.

How do you remove Mighty putty?

If you want to remove Mighty Putty, first soften it with acetone. You can also use fingernail polish. Then rub it off using a putty knife. Be careful and gentle while scraping so that you do not damage or scratch the item holding the putty.

How long does epoxy putty last?

Physical properties

Appearance Dark Gray/Light Gray Stick
Temperature limits – continous -40°C to 121°C
Temperature limits – intermittent -40°C to 149°C
Chemical resistance Resistant to hydrocarbons, ketones, alcohols, esters, halocarbons, aqueous salt solutions and dilute acids and bases.
Shelf life (at 24°C) 24 months minimum

How long should epoxy dry before sanding?

48 hours
Tip: The epoxy resin must be really dry before sanding. You should therefore allow a waiting period of at least 48 hours before processing. Follow the manufacturer’s instructions, as there are resins that take even longer to harden completely.

How long does it take for epoxy to get tacky?

General about Epoxy Resin Dry Time Usually, it takes around 72 hours to fully cure the epoxy. Whatever the dry time, the resin should be allowed to fully cure before attempting to move or sand it. If the epoxy isn’t allowed to rest until fully cured, your project will be prone to surface contamination.

Share this post