Why does the faucet leak after replacing cartridge?
Your faucet may contain a ceramic, brass, or rubber seat that is meant to form a seal at the bottom of the cartridge opening. The seat can become damaged with use so that it no longer fits correctly into the hole in the cartridge, which allows water to leak. The O-ring may also become cracked and cause a leak.
How do you fix a leaky faucet after replacing the cartridge?
Spread a thin layer of plumber’s grease around the cartridge. Push the faucet cartridge into the faucet, aligning it with the notches. Then tighten the large retaining nut with the wrench and replace the handles. Kits containing faucet repair parts are readily available at hardware stores and home centers.
How long should shower cartridge last?
The valves are easy to move against pressure. Control the volume from off to full on by leaving them set to the same temperature. The system costs about $30 to replace, but they last for 20 to 30 years.
How do you remove a faucet cartridge?
To remove the cartridge from your faucet assembly, first use a flat-headed screwdriver to carefully pry the cover from the handle. Using a Philips screwdriver unscrew the handle screw. Pull the handle off from the faucet and pull the limit stop off.
How do you replace a shower faucet cartridge?
How to Replace a Shower Cartridge: Step by Step Step one: Gather your supplies Step two: Prepare Step three: Remove the handle Step four: Remove the faceplate that surrounds the cartridge Step five: Remove the metal sheath surrounding the shower cartridge Step six: Remove the pin holding the cartridge in place Step seven: Remove the cartridge
How do you repair a leaking faucet?
How To Repair Compression Faucet Leaking Water (Reverse Compression) 1. Turn both water supply lines to the faucet OFF. 2. Loosen the set screw on the faucet handle. 3. Remove the faucet handle/knob. 4. Unscrew and remove the valve stem.
How do you replace a faucet stem?
How to Replace a Faucet Valve Stem Step 1 – Turn Off the Water and Faucet Step 2 – Cover the Drain and Open Handle Step 3 – Take Notes and Remove Screw Step 4 – Remove Handle and Disassemble Step 5 – Remove Stem and Go to the Store Step 6 – Check the Washer and Replace Fittings Step 7 – Replace Parts and Test