What size nut is on a hot water heater element?

The right socket for water heater element is Drive x 1-1/2 inches socket. Designed to properly the all common size electric heater elements, this socket’s opening will snugly fit the hex end.

How do I loosen a stuck water heater element?

Mix a solution of half vinegar and half water in a small cup. Dip a toothbrush into the solution and brush it between the seam of the heating element and the side of the heating tank. Apply the solution liberally, but do not allow it to drip heavily. Allow the solution to sit for 20 minutes.

Does RV Water Heater have a thermostat?

The RV water heater can be operated in either mode or both can be used to speed up the heating process. Both are controlled by a thermostat, so the heater only runs as needed. Most water heaters have separate thermostats for Electric and LP Gas modes and the two modes are pretty much independent of each other.

Can you adjust temp on RV water heater?

Many RVers complain that the water is too hot. Gary shows how a gas water heater works, then explains Atwood Mobile Products’ service kit that includes an adjustable thermostat. So, swap out the original, non-adjustable thermal limit switch for an adjustable thermostat.

How hard is it to change a heating element in a hot water heater?

The task of replacing a water heater element may seem difficult, but most homeowners can make this repair themselves. If your water heater is slow to heat, runs out of hot water, or doesn’t deliver hot water at all, there’s a good chance that one or both of your heating elements are not working properly.

What should the thermostat be on an RV?

A quick how to on changing the thermostat on the RV water heater. Most RV water heaters are set at 140 degrees … a tad too hot.

What kind of wrench do I need for RV water heater?

Camco’s drain plug wrench is specifically designed for use with RV water heater drain plugs. The angled design conveniently fits in tight spaces and includes prongs for rusted drain valves and petcock drains. Fits both 7/8″ and 15/16″Drain plugs.

Can you remove an electric hot water heater element for free?

Don’t BUY tool to remove electric hot water heater element – BORROW it for FREE! – YouTube

Where is the drain plug on a CAMCO hot water heater?

The design layout of the hot water heater is really crummy in that it makes it really hard to access the drain plug to remove the water from the tank at the end of the season. The 15/16″ drain plug is blocked by other associated hardware, making traditional wrenches unable to access the plug.

Share this post