Where is the routing information on a drive belt?
The serpentine belt routing diagram is usually located on a tag in the engine compartment. If it is not found there, it can be accessed in a repair manual, such as Chilton’s Online Repair Manual.
Does a 2003 Honda Accord have a serpentine belt?
It is recommended to replace the serpentine belt in your Honda every 60,000 – 100,000 miles or as necessary if it appears damaged. This guide covers changing the serpentine belt (drive belt) on a 2002, 2003, 2004, 2005, 2006, and 2007 Honda Accord with the 2.4L engine (4 cyl.).
How do you change a belt on a Honda Accord?
Honda Accord: How to Replace Serpentine Belt
- Step 1 – Locate the tensioner pulley. From a front-on angle, the tensioner pulley is below and to the left of the top most large pulley.
- Step 2 – Loosen the belt.
- Step 3 – Remove and replace the belt while the tension is off.
- Step 4 – Start the engine and inspect the belt.
How much does it cost to replace a serpentine belt on a Honda Accord?
Honda Accord Serpentine Belt Replacement Cost Estimate. The average cost for a Honda Accord serpentine belt replacement is between $92 and $111. Labor costs are estimated between $46 and $58 while parts are priced between $46 and $53. This range is based on the number and age of Honda Accord’s on the road.
How do you replace a belt on a Honda Accord?
Be sure that when replacing the old belt with a new one, you follow the same pulley sequence, which should be shown on a sticker under the hood or in your maintenance manual. If you purchased an OEM replacement belt or any other belt for that matter, the reverse side of the package may also have the diagram.
Why does the serpentine belt on my Honda Accord crack?
It’s most likely the serpentine belt. If your serpentine belt is old, stretched, cracked and squealing, it is due for a replacement! Follow this picture guide to quickly and easily change the serpentine belt (also called ‘drive belt’) in your Accord! What does a serpentine belt do?
How do you release tension on a Honda Accord?
To release the tension on the tensioner pulley, put a 14mm wrench onto the nut-head on the tensioner pulley (A), and pull the wrench toward the front of the car as shown. On the Honda Accord, this is a 14mm hex head on the tensioner pulley.