Why is my VSC and ABS light on?

If the brake system is malfunctioning, the traction control light might come on as a result. The light for your ABS might also come on if the brake fluid is low. Your car likely has sensors in those tanks in order to detect when fluids are low, which could be dangerous.

How do I fix the VSC on a 2008 Toyota Highlander?

VSC Light Easy Fix

  1. Make sure you are completely stopped. Put the car in park if you can.
  2. Press and hold the VSC button for a few seconds.
  3. The TRAC OFF and VSC OFF indicator light will come on. Both systems are now off.
  4. Press the VSC button again. Both lights will turn off and the systems are now reengaged.

How do you reset the VSC light on a 2008 Toyota Highlander?

Park the vehicle, turn off the engine and set the parking brake. Open the vehicle’s hood and disconnect the battery’s negative cable for 15 seconds, using an appropriate size socket. Disconnecting the negative battery cable will reset the vehicle’s computer and clear the “VSC” warning.

How do you reset the ABS light on a Toyota Highlander?

How to Reset Toyota ABS codes and light

  1. Connect your OBD-II diagnostic tool to the diagnostic port located under the driver dash area.
  2. Turn on your ignition two clicks; do not turn on the engine.
  3. Allow the OBDII tool to communicate with your car.
  4. Select the Toyota model or do an auto scan.
  5. Scroll down to the ABS module.

What would cause the VSC light to come on?

The wheel sensors provide information about the motion and rotation of the wheels in order to determine which wheels need the braking power. If you notice the VSC light comes on, you might be having problems with your sensors or the steering system.

How do you turn off ABS light?

Locate the DIC control panel on the dashboard in front of the driver’s seat under the speedometer. Keep pushing and releasing the “Set” button on the DIC control panel until “ABS” is shown. Hold the “Set” button for about 5 seconds to reset the light and turn it off.

Can you still drive your car with the ABS light on?

Is It Safe To Drive With An ABS Light? When your ABS light comes on it doesn’t mean your vehicle isn’t safe to drive from point A to point B. The car will still function as normal, it will start up just fine and drive how it always has and your brakes will work as well.

What makes the VSC light stay on on a Toyota Highlander?

Check VSC System Diagnosis: Toyota Highlander. 1 1. Loose/Bad Fuel Cap. Although it seems like it would be counterintuitive, a bad/loose gas cap can make the VSC light stay on. This should be the 2 2. Bad Wheel Speed Sensor. 3 3. ABS System Issues.

When does the ABS light come on in a Toyota Highlander?

When driving down highway and needing to suddenly brake, abs light and check vsc system lights came on, the car did brake in time. However, soon afterwards the brakes did not immediately engage when reversing out of parking space or anytime when pressing brakes while reversing.

What are the brake warning lights on a Toyota Highlander?

Tl- the contact owns a 2006 Toyota Highlander. While driving approximately 30 mph, the brake and abs warning lights illuminated. The contact stopped the vehicle and shut the engine off. The vehicle was able to be restarted but would not shift out of park.

Are there any problems with the Toyota Highlander?

See all problems of the 2011 Toyota Highlander . Braking became erratic. Pedal was squishy and abs lights came on. This occurred over several months but on an intermittent basis. Lights would go off for a while then come back on. See all problems of the 2008 Toyota Highlander .

Share this post